Barco R9050100, User Manual

Page: 169 / 233

14. Service menu
When the projector was in standby while selecting Re fi ll mode, then the water-cooling pump will start pump-
ing. Repower the projector to fi nish the re fi lll mode.
When the projector was playing, it remains playing.
14.8 USB memory
What is possible with an USB device?
An USB device, FAT 16 formatted can be used, to save custom settings from the projector or to load custom settings to the projector.
This function is very handy to clone projectors.
The following settings can be transported via an USB device:
• baudrate
• address
• common address
• orientation
• text on/off
• fi le load mode
• eco mode & dimming
• rs232 interface & rs232 termination
• no signal setup settings
• IR receiver settings
• native resolution
• min delay
• current language of on screen menus
• customer id
• Network settings (DHCP, IP address, net mask, gateway address)
• blanking & keystone
• ScenergiX
• gamma
• color standard
• source switching
• effect settings
• menu position
• button settngs
• locking settings
Saving custom settings
1. Connect a FAT 16 formatted USB device to the USB port.
2. Press MENU to activate the menus.
3. Use the ▲ or ▼ key to select Service and press ENTER .
The service window opens.
4. Use the ▲ or ▼ key to select USB memory and press ENTER .
5. Use the ▲ or ▼ key to select Save custom settings and press ENTER .
R59770021 CLM R10+ 15/03/2010 165