![background image](http://html1.mh-extra.com/html/barco/r9006332b1/r9006332b1_user-manual_4250685035.webp)
RLM W14 17/04/2017
27
4.Physical Installation
5. Install a U-bolt on the lens holder, with the open ends oriented outwards (reference 3). Make sure that both a part of the
loop end and the outgoing part of the safety cable are placed in the enclosure.
3
3
6. Close the U-bolt and tighten it.
Note: Make sure the safety cable is tightened around the lens before tightening the U-bolt nuts.
7. Place the shackle through the free loop end of the safety cable.
4.4 Installing the lens with safety cable on an RLM projector
This procedure assumes you know how to install a lens into the projector. If not, refer to the installation
manual of the projector.
How to install on RLM projectors
1. Place the lens in the lens holder, using the lens locking
mechanism.
Caution: Always make sure the lens is really secured by trying to pull
the lens out of the lens holder.
2. Snap the shackle through the fixation ring near the lens opening.
3. Secure the shackle by screwing the safety ring of the shackle over
the open end.
How to remove the lens
1. Follow the drawing to press the button
2. Press down the lever to release the lens
3. Pull out the lens.
Summary of Contents for R9006332B1
Page 1: ...RLM W14 User manual...
Page 92: ......