![background image](http://html1.mh-extra.com/html/barco/r9004460/r9004460_owners-manual_4265878019.webp)
2. Installation Guidelines
Image 2-6
Mounting lens
For cleaning the lens, see "Cleaning the lens", page 122.
2.6
Mounting the lamp house
C
AUTION
:
Never transport the projector with the lamp casing installed. The lamp casing should always been
transported in a vertical way to avoid damaging the lamp.
W
ARNING
:
Never attempt to disassemble the lamp from its housing or to dispose of it other than by returning
it to Barco. Due to its high internal pressure, the lamp may explode in either hot or cold state.
Necessary tools
•
Nut driver 10mm
•
Flat screwdriver 5mm
Installing the projection lamp
1. Unplug the projector from the wall outlet.
2. On the input side of the projector, remove the side by turning the 3 quarter turn fastener studs a quarter turn counter clockwise.
3. Pull the top side of the cover out of its spring locks.
4. Take the lamp casing by both handles carefully out of its shipping box.
5. Place the lamp casing on the optical base plate.
6. Push the lamp casing forward until the lamp slide fully into the projector. Both center pins (A) must match both center (B) holes.
If the center pins match the holes, the safety switch (C) will be activated (lamp ignition is possible).
R59770014 XLM HD30 07/07/2006
15
Summary of Contents for R9004460
