Barco Prometheus III, Installation Manual

Page: 28 / 200

R5906897 /02 Prometheus III 28
Save the original shipping carton and packing material, they will be necessary if you ever have to
ship your projector. For maximum protection, repack your projector as it was originally packed at the
factory.
The projector is delivered with a plastic cover inside the Lens Holder. This to prevent intrusion of
dust and foreign particles.
The lens is delivered in a separate box. For lens installation, see section “ Lens & lens holder ” .
2.4 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As
soon as the projector is unpacked, inspect for any damage that may have occurred in transit. Save all packing
material until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco
Sales and Service office should be notified as soon as possible.
Projector Box content
After unpacking the projector it is recommended to check if all following items where included:
• One short power link cable (mono phase) (in case no UPS is used) - Installed on projector.
• A short information notice to inform the user that installation manual (this manual) is available online on the
Barco website.
• Safety manual
The projector lens are not included in the package of the projector.
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces
are free of dents and scratches, and that the operating panel is not scratched or cracked. The Barco Sales
and Service office should be notified as soon as possible if this is not the case.
Tamper labels
During installation please inspect the tamper labels, if they are damaged please contact Barco tech support.
The tamper labels are required by DCI to provide easy visual indication if the equipment was tampered with.
The projectors are tested and labeled for shipping to ensure that the system was not compromised before
reaching the customers final destination.
These tamper labels can be found behind the input cover. See “ Removal of the input cover ” , page 138.
General