Barco Prometheus III, Installation Manual

Page: 25 / 200

R5906897 /02 Prometheus III 25
1
2
Image 2-8
1 Cooler
2 Metal grid
This optional grid is delivered only in the Stand alone pack accessories. For further details, please
see section dedicated to the physical installation of the stand alone cooler.
2.3 Unpacking the projector
What has to be done ?
Upon delivery, the projector is packed in a carton box upon a wooden pallet and secured with banding and
fastening clips. Furthermore, to provide protection during transportation, the projector is surrounded with
foam. Once the projector has arrived at the installation site, it needs to be removed from the carton box and
wooden pallet in a safe manner without damaging the projector.
After unpacking let the projector acclimatizes to a room temperature higher then 10°C (50°F) and
lower then 35°C (95°F). It is suggests only using it after having stored it for 16 hours in final location.
Neglecting this may result in a start up failure of the Light Processor Unit.
Required tools
• 8 mm Allen wrench.
• 13 mm open end wrench.
• 17 mm open end wrench.
How to unpack
1. Loosen the banding by pulling the free end of the banding loop in the clip.
Take off the box cover.
General