6. Installation of Projection System
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006
September 2006
September 2006 ________________________________
________________________________
________________________________
________________________________________________________
________________________
________________________
________________________6-13
•
Close the lamp door
•
Use the screw driver and lock the lamp door by turning the screw a quarter turn clockwise.
The Serial Number of the lamps have to be entered, cf.
In addition, Lamp
Optimization has to be performed once for both lamps, cf.
. It is
recommended to do these step as soon as possible.
6.6
Inserting the Lamp Modules (Illumination unit with lamps of 200W)
•
Fetch the lamp module on its housing. The power socket is on the right side.
•
Insert the lamp carefully. Take care that the "tubes" slide on the guide rods.
•
When the lamp is removed, you see the two guiding rods on the upper right/lower left and the additional
fan for cooling.
•
Press the lamp module tightly into its socket.
•
Lock the lamp into its position by pressing the locking slider to the left.
Figure 6-16
inserting the lamp and locking it
