Barco - NSL-4601 - User manual ______________________________________________________ 13
Installation
4
Installation
4.1
Installation precautions
•
Keep the original packaging. It is designed for this unit and is the ideal pro-
tection during transport.
•
Allow adequate ventilation in case the configuration is built in a rack or a
console, so that the heat can properly dissipate.
•
For units where the power cable or connector is the primary means of
detaching the system from the power supply. One of the cable ends (or
power connector) should be easily accessible.
•
Make sure all units are disconnected from mains before connecting the sig-
nals.
•
The display unit must be earthed correctly, as described in the safety pre-
cautions paragraph.
•
Before connecting the unit to mains, check if the power source voltage cor-
responds to the mains voltage marked on the identification label on the dis-
play.
4.2
Specific installation precautions
•
The panel is foreseen with 2 handles at the rear side of the panel for easy
transportation. During installation or transportation, 2 people should lift an
edge of it by holding the handle.
•
Do not grip the front of the panel, the panel may get damaged when to
much pressure is applied. The display is slim and fragile, handle it carefully.
•
Do not incline the panel forward, the edge or bottom of the panel could be
damaged.
•
In case the panels need to be tiled on a wall, make sure the edges do not
collide with eachother during the installation, the edges could be damaged.
