Barco Nio Fusion12MP, User Manual

Page: 38 / 66

R5913350 /02 Nio Fusion 12MP 38
To select the DisplayPort standard version
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort 1/2 menu.
3. Enter the Input Interface Standard Version submenu.
4. Select one of the available versions and confirm.
To obtain full resolution and full refresh rate, DP V1.2 should be selected and two DisplayPort video
input cables must be connected to the display.
4.24 EDID format
About EDID format
Following EDID formats are available for your Nio Fusion 12MP:
• EDID 1.4: Factory default setting and advised for a single workstation setup (see “ Single workstation
setup ” , page 12).
• DisplayID 1.3: Necessary to drive 12MP (i.e. 4200x2800) resolution over 1 video cable. Advised for a dual
workstation setup with KVM switch (see “ Dual workstation setup with KVM switch ” , page 13).
To set the EDID format
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort 1/2 menu.
3. Enter the EDID format submenu.
4. Select one of the available formats and confirm.
4.25 EDID timings
About EDID timings
Following EDID timings are available for your Nio Fusion 12MP:
• Resolution : Allows to manually modify the resolution of the image source video input signal:
- 5.8MP : 2096 x 2800
- 6MP : 2100 x 2800
- 12MP : 4200 x 2800, only available when the EDID format is set to DisplayID 1.3
• Refresh Rate : Allows to manually select the refresh rate of the image source video input signal depending
on the maximum refresh rate of the display controller connected to your display.
• Color Depth : Allows to change the color depth to 8 or to 10 bit.
To set EDID timings
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort 1/2 menu.
3. Enter the EDID submenu.
4. Select one of the available settings and confirm.
Advanced operation