Barco MDSC-8255 12G, User Manual

Page: 21 / 72

21 R5913964 /00 MDSC-8255
2
3
1 5
4
6
+5VDC
Image 3 – 1
DisplayPort VESA DP 1.2 certified cables for 5.4 Gbps HBR2 with a length of up to 3 m are
recommended.
Premium certified HDMI 2.0 cables with a length of up to 3 m are recommended.
3G-SDI Belden 1694A cables with a length of up to 50 m and 12G-SDI Belden 4855R cables with a
length of up to 30 m are recommended.
The DVI output must be enabled in the OSD menu (please refer to “ DVI output ” , page 48).
A subset of the commands of the remote control protocol is also available on a new DDC protocol
on DVI and DisplayPort1 auxiliary channel.
3.1.2 MDSC-8255 MNA
To connect the interfaces
1. Connect one or more video source(s) to the corresponding video inputs of the display. For a list of
supported video inputs and timings, see “ Technical specifications ” , page 64.
2. When the SDI video input is connected, an additional SDI video sink can be connected to the SDI output (=
SDI input loop-through).
3. Screen image clone: The entire active image on the screen (including OSD) can be duplicated to a FHD
(1080p/1080i) signal on the DVI output connector, to which an additional DVI video sink can be connected.
4. Use any USB peripheral (keyboard, mouse, webcam, ...) by connecting it to the available USB interfaces.
5. Con5 VDC - 2A power out for accessory (Mating connector HIROSE RP34L-5PA- 2SC(1857)(71))
6. Connect a headphone to the appropriate output to listen to audio sent over Nexxis.
7. Connect a microphone to the appropriate input to send spoken audio over Nexxis.
8. Connect a (set of) speaker(s) to the line out interface to listen to audio sent over Nexxis.
9. Connect any kind audio player to the line in interface to send audio over Nexxis.
10. Connect the display with Nexxis to use the remote control protocol or to update the display firmware.
Installation