Barco MDPC-8127, User Manual, Page: 17 / 52

17 R5913216 /03 MDPC-8127
To register your display system to your QAWeb Enterprise organization, the QAWeb Enterprise Agent must be
installed and running on your workstation and it must be able to communicate with the QAWeb Enterprise
cloud service.
For more information and installation instructions, please check the QAWeb Enterprise user guide on
www.barco.com/support .
2.6 VESA-mount installation
CAUTION: Use suitable mounting apparatus to avoid risk of injury.
WARNING: Never move a display attached to an arm by pulling or pushing the display itself.
Instead, make sure that the arm is equipped with a VESA compliant handle and use this to move
the display.
Please refer to the instruction manual of the arm for more information and instructions.
WARNING: Use a mount that is compliant with the VESA 100 mm standard.
Use a mount that can support the weight of the display. Refer to the technical specifications of this
display for the applicable weight.
Overview
The panel, standard attached to a stand, is compatible with the VESA 100 mm standard. Thus, it can be used
with an arm that is approved by VESA. This chapter shows you how to release the panel from the stand and
how to attach it to an arm. If you
’ re not using an arm, you can skip this chapter.
1. Unlock the stand locking mechanism and put the display in the highest position.
Image 2 – 6
2. Put the display face down on a clean and soft horizontal surface. Be careful not to damage the panel
screen.
3. Push the VESA mount cover to the right and lift the cover on the right with your finger or a flathead
screwdriver.
Installation and setup