7. Getting started
7.4.3
Adjusting the gamma
Description
The gamma setting de
fi
nes the reproduction of the mid tones of a projected image. A correct gamma setting results in a maximum
of gradations (brightness levels) in the projected image.
The gamma can be set in the range 0 to 3.2 (in steps of 0.2). Default value is 2.2. This value should meet the gamma setting of the
source (e.g. graphical card of a computer that is used as a source). In case of doubt, leave the gamma to its default setting.
How to adjust gamma?
1. In the OSD, navigate to
Image
>
Settings
>
Gamma
... and press
ENTER
to select.
Image 7-34
2. In the dialog box, select the source for which you want to change the gamma.
Image 7-35
3. Change the value to your wishes.
Image 7-36
4. Exit the menu.
50
R5909057 MCM-50 17/05/2016
Summary of Contents for MCM-50
