13. MCM-50 Tools
Image 13-12
2. Use
▲
and
▼
to position the status bar.
13.7 Positioning the slider box
Description
The Slider box (for e.g.
Contrast
...) can be moved around the full image in random steps and in small steps. This can be useful in
applications where part of the image is not visible on screen (e.g. Soft Edge area).
Moving the Slider box
1. In the OSD, navigate to
Display setup
>
Sliderbox position...
and press
ENTER
to select.
Image 13-13
A slider box is displayed.
2. Use the arrow keys on the RCU to position the slider box.
You can toggle between standard or small steps to move the slider box position by pressing ENTER when
slider box is displayed.
13.8 Sync Variance Limit
Description
The Sync Variance Limit allows to generate a certain delay between the incoming signal and the processing of it. It is expressed in
source lines.
The reason why this delay is needed is because the signal processing in the device is faster than the source signal itself.
If the Sync Variance Limit value is set too low, the previous frame will be processed. This implies that the delay between incoming
signal and display of it will be large (16 ms). No image distortion will occur however.
R5909057 MCM-50 17/05/2016
129
Summary of Contents for MCM-50
