23
1
Check to ensure that this projector, computer, and switching hub are properly connected
2
Connect the power cord to the power input terminal of this projector
3
Insert plug into the power outlet on the wall
4
Remove the lens cap
5
Turn on the main power of the projector to set to [I]
●
The [STANDBY/ON], [LAMP], and [WARNING] indicators light up for about 45 seconds, after which the
[STANDBY/ON] indicator turns red.
NOTE:
●
The default IP address of all LX-5 is “192.168.0.2”. If multiple units of LX-5 are used on the same network, do not turn
on the main power of more than one projector unit at the same time. Doing so will result in duplication of the IP address,
and thereby preventing proper access.
●
When using multiple units of LX-5, turn on the main power of the second unit and configure accordingly only after
configuration of the first unit is complete. Configure subsequent units using the same procedure.
●
When duplication occurs in the IP address, make sure that only one unit of LX-5 is connected on the same network
(turn off the main power of the other LX-5 units). Allow a time interval of at least 10 minutes before accessing. If access
fails, turn off the power of all network equipments on the same network, followed by turning them on again.
Turning On the Main
Power
5
2
3
CAUTION:
●
Do not connect the power cord when a lens (optional)
is not attached.
Power Cord
(Supplied)
LX-5_EN.book Page 23 Friday, July 4, 2008 9:35 AM
