ImagePRO-II • User’s Guide
11
2. Hardware Orientation
ImagePRO-II Front Panel
fåéìí=_ìííçåë
Input buttons 1 through 5 correspond to the five standard input connectors on the rear
panel. These buttons select the source signal that you want to display.
Figure 2-5.
ImagePRO-II Input Buttons
The sixth button is reserved for use with the optional 3D/Dual Channel mezzanine.
•
Press
Input Button 1
to select the source on the
DVI
(digital or universal analog)
connector.
•
Press
Input Button 2
to select the source on the
HD-15
(universal analog)
connector.
•
Press
Input Button 3
to select the source on the
HDMI
connector.
•
Press
Input Button 4
to select the source on the
DisplayPort
connector.
•
Press
Input Button 5
to select the source on the
SDI
-
1
connector.
•
Press
Input Button 6
to select the source on the
SDI-2
connector, when the
3D/Dual Channel mezzanine is installed.
For details about supported resolutions and HDCP compatibility for each input, refer to the
“
” section on page 13 of this chapter, or to the “
” section of Appendix A, on page 161.
qÜÉ=ildl=_ìííçå
The
LOGO
button beneath the input buttons can serve as an additional image source.
Using
LOGO
, you can capture, import, and store a still output frame in non-volatile
memory, then transition to and from that still frame. For more information about using
LOGO
, refer to the”
Using a Logo or Internal Black
” section of Chapter 4 on page 96. For
more information about transitioning, refer to the “
” section on page 83.
qÜÉ=_i^`h=_ìííçå
The
BLACK
button transitions the display to and from black. For more information about
BLACK, refer to the “
” section of Chapter 4 on page 100.
qÜÉ=cow=_ìííçå
Pressing the
FRZ
button temporarily freezes the displayed video. If
FRZ
is lit, the following
actions turn it off:
•
Pressing
FRZ
again
•
Pressing the input button for the displayed image
When you freeze an image, the
PAN/ZOOM
button is not operational, and the
Input Setup
and
Views
menus are not accessible.
6
SDI-2
2
3
HDMI
5
SDI-1
1
DVI-I
4
DP
2
HD-15
Note
A customer-supplied
DVI to HD-15 adapter
is required to
connect analog video to the DVI connector.
LOGO
BLACK
FRZ
