ImagePRO-II • User’s Guide
115
4. Menu Orientation
Operating the ImagePRO-II in 3D Mode
pÉííáåÖ=ré=fåéìíë=íç=aáëéä~ó=páåÖäÉJpíêÉ~ã=Pa=sáÇÉç
To set up the ImagePRO-II to display single-stream 3D video, use the following
procedure:
1.
Select
System
>
System Mode
>
3D
.
2.
When prompted to save this configuration, press
SEL
.
3.
Set up the inputs you want to use. On the
Input Menu
, select
Processing > 3D
Mode
. This option sets the packing mode for 3D video, determining how the input
signal is processed and sent to the output display. The available options are:
~
Off.
This is the default setting.
~
Side
. The left and right images are scaled and displayed side by side on
a single connector.
~
Top/Bottom
. Left and right images are scaled and displayed on a single
connector. The left image is on top by default and the right image is on
the bottom by default.
~
Sequential
. The left and right images are processed in sequence at up
to 120 Hz -- left then right then left, and so on -- displaying the full image
on one connector.
This option is available on the DVI, DisplayPort and HDMI connectors.
DVI supports formats up to 330 MHz pixels (1920x1200p@120 MHz).
DisplayPort supports formats up to 300 MHz pixels (1920x1080p@120).
HDMI supports formats up to 165 MHz (1280x720p@120).
~
Left/Right.
The complete left and right images are displayed on different
output connectors. You can use this option with the following pairs of
connectors:
•
The
DVI and HDMI
connectors, with the DVI as the left image
by default, and the HDMI as the right image by default.
•
The
SDI 1 and SDI 2
connectors, with SDI1 as the left image by
default and SDI2 as the right image by default.
~
FramePack
. This option is a special video timing for HDMI video.
4)
If you want to swap the left and right connectors, scroll to
3D Swap
. This option
lets you switch default settings, or display only the right image or only the left
image as standard 2D video. The options are:
~
Off
. This is the default setting.
Top/Bottom
1920x1080p @23.98 Hz
1920x1080p @24 Hz
1280x720p @50 Hz
1280x720p @59.94 Hz
1280x720p @60 Hz
Sequential
Sequential progressive frames up to
2048x1200 @120 Hz (24 bits) on the DVI dual-
link and DisplayPort connectors
Table 4-4.
Supported Input/Output Resolutions — Single-Stream 3D Video
Signal Format
Resolutions
Note
The
3D Mode
for an output must match the
3D Mode
for the
corresponding input.