Barco iD H250, Owner'S Manual

Page: 62 / 106

7. Advanced
Image 7-34
The film mode detection insures that these converted signals are shown without artefacts, especially motion artefacts due to bad
de-interlacing.
This function may cause undesired effects on standard sources, therefore it can be disabled (OFF) at any time
Enabling/disabling the film mode detection
1. Press
MENU to activate the Tool bar
2. Press → to select the
Image
item
3. Press ↓ to Pull down the
Image
menu
4. Use ↑ or ↓ to select
Film mode detection
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable or disable the Film mode detection
Image 7-35
7. Press ENTER
A white bullet shows the active setting
7.5.5 Input balance
Introduction: Unbalanced color signals
When transporting signals, there is always a risk of deterioration of the information contained in the signals.
The alterations of the three color signals will happen independently i.e. the colors will end to be unbalanced,
58 R59770079 BARCO ID H250/500 23/07/2007