Barco ICP-D, Installation Manual

Page: 25 / 54

25 R5912083 /01 ICP-D
3.6 Authorization to clear a security warning on
series 2 projector
When is an authorization required to clear the security warning?
If a module has been removed or if the sealed compartment has been opened, an authorization will be
required to clear the security warning.
The procedure varies depending on the projector type.
Required tools
• Authorization pin code.
• Security key (Dallas iButton®). Only needed on DPxK-B/BLP/C/CLP series.
Authorization procedure to clear security warning on DPxK-B/BLP/C/CLP series
1. Ensure that all modules are properly installed.
2. Start up the projector (standby mode).
3. Initiate authorization by holding the security key in the security socket (reference 1)..
1
1
2
3
4
5
6
Image 3 – 4 Keypad
The color of the backlight of the numeric keys 1 to 6 of the local keypad changes from blue to yellow.
4. Enter pin code within 5 seconds.
• In case no keys are pressed, the color of the backlight of the numeric keys 1 to 6 changes back to blue.
• In case of an incorrect code entry, the color of the backlight of the numeric keys changes to red for 1
second and then back to blue.
• In case of a correct code entry, the color of the backlight of the numeric keys 1 to 10 changes to green
for 1 second and then back to blue.
Authorization procedure to clear security warning on DPxK-S/SLP/L series
1. Ensure that all modules are properly installed.
2. Start up the projector (Standby mode).
3. Initiate authorization by pushing the Key button on the Local Keypad:
The color of the backlight of the Numeric keys 1 to 6 of the Local Keypad changes from blue to yellow.
4. Enter pin code within 5 seconds.
• In case no keys are pressed, the color of the backlight of the Numeric keys 1 to 6 changes back to
blue.
ICP-D installation