Barco HDX series, User And Installation Manual

Page: 20 / 340

2. General
One xenon lamp is mounted inside the lamp house at delivery. The projector lenses are not included in the
package of the projector.
Mechanical check
This check should con fi rm that there are no broken knobs or connectors, that the cabinet and panel surfaces are free of dents and
scratches, and that the operating panel is not scratched or cracked. The Barco Sales and Service of fi ce should be noti fi ed as soon
as possible if this is not the case.
2.4 HDX fl ight case
Introduction of the HDX fl ight case
The HDX fl ight case is designed to transport the HDX projector in a safe and secure manner. The four caster wheels, provided with
breaks, and the four handles make the HDX fl ight case easy to handle. The fl oor of the fl ight case wagon is equipped with two small
covered compartments to store the remote control and the rigging clamps.
Image 2-3
HDX Flight case
Order number fl ight case: R9864090
The dimensions of the fl ight case are optimal for maximum utilization of the fl oor area of a truck. The cover of the HDX fl ight case
has 4 stacking dishes, which allows to stack the fl ight cases.
W
ARNING
:
Maximum stack two (2) HDX fl ight cases high. Never higher.
2.5 Projector con fi gurations
The different con fi gurations
Depending on the installation the projector can be mounted in different ways, the different con fi gurations are:
1. Front / Table (F/T)
2. Front / Ceiling (F/C) (upside down)
3. Front / Ceiling (F/C) (table position)
4. Rear / Table (R/T)
5. Rear / Ceiling (R/C) (upside down)
6. Rear / Ceiling (R/C) (table position)
Front projection
The projector is installed, either in a table mount or ceiling mount con fi guration, at the same side of the screen as the audience.
16 R5905032 HDX SERIES 20/11/2014