Barco HDX series, User And Installation Manual, Page: 185 / 340

12. Alignment
12.8.10 Selecting and changing the position of a speci fi c point
About point selection
Depending on the warp level, number of selectable points, a speci fi c point can be selected and moved in any direction. The coordi-
nate system works with 33 x 33 pixels (0 to 32). Depending on the warp level the cursor will jump from active point to active point.
E.g. for 5 x 5 the fi rst point has coordinates (0,0), the second point in horizontal direction will have coordinates (12,0), etc. .
How to select a point
1. Select the warp level (1).
1
3
2
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
0 2 1 3 4 6 5 7 8 10 9 11 12 14 13 15 16 18 17 19 20 22 21 23 24 26 25 27 28 30 29 31 32
1
21
11
6
16
5 3 2 4
25
15
23
13
24
22
10
20
8
18
12 14
7 9
19 17
Image 12-46
Point selection
2. Select Warp mode points (2).
3. Use the ▲ or ▼ key to go to Point selection.
4. Select alternating the X and Y coordinate and change the value (3).
Or,
press
ENTER to open the point selection window.
Use the 4 arrow keys to select the desired point.
Press
ENTER to the Warping adaptations.
Image 12-47
Point selection Image 12-48
Moving selected point
5. Use the 4 arrow keys to change the position of the selected point.
12.8.11 Scaling the image
About scaling
It is possible to scale the whole image. This is considered as an equal scale of the 4 corner points in 2 x 2 mode. The Warping
adaptation window is used to scale the image.
How to scale
1. Select the 2 x 2 adjustment level. See "Setting the warping level", page 177.
The default selected anchor point is the left top corner of the image.
2. Select the desired warp area.
R5905032 HDX SERIES 20/11/2014 181