7. Maintenance
7.7
Removal of the Lamp House
W
ARNING
:
The procedure below may only be performed by “quali
fi
ed service technicians”.
W
ARNING
:
Before removing the Lamp House, disconnect the power to the projector mains terminals and
unplug the power cord at the UPS INLET for removal of all power from the projector.
Necessary tools
10 mm nut driver or
fl
at screwdriver
How to remove the Lamp House from the projector?
1. Remove the lamp cover.
2. Release the two retaining screws (1) at the base of the Lamp House. Use a 10 mm nut driver or a
fl
at screwdriver.
3. Remove the Lamp House:
a) Grip the Lamp House with the bottom handle (2) and partially slide it out of the Lamp House compartment.
b) Grip the Lamp House with the top handle also (3) and remove it completely from the projector.
c) Place the Lamp House on a solid and stable support.
Warning:
Be aware of the weight of the Lamp House. Take the necessary precautions to avoid personal injury.
1
2
3
Image 7-5
Removal of the Lamp House
R5905823 HDQ 4K35 30/11/2015
77
Summary of Contents for HDQ 4K35
