Barco HDF-W30LP, User And Installation Manual

Page: 283 / 311

22. Removal and installation of the projector covers
22. REMOVAL AND INSTALLATION OF THE PROJECTOR
COVERS
About this chapter
Most maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts to
maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, with
detailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only be
removed by quali
fi ed service personnel, see remarks above each procedure.
W
ARNING
:
Always switch off the projector and unplug the power cord at the projector side before removing
one of the covers.
22.1 Removal of the front cover
W
ARNING
:
This procedure may only be performed by quali fi ed technical service personnel.
Necessary tools
7 mm fl at screw driver.
How to remove the front cover
1. Remove the lens. See “Lens removal ”.
2. Remove the rubber dust ring from the lens holder.
3. Release the captive screw at the middle bottom of the front cover, using a
fl at screw driver.
Image 22-1
Captive screw
4. Remove the front cover from the projector as follows:
a) standing in front of the projector, pull the right side of the front cover toward you until the latches release (left side is hinged)
b) then slide the front cover to the right to release it from the hinging points.
R5906730 HDF WLP SERIES 01/08/2017 279