Barco HDF-W30LP, User And Installation Manual

Page: 151 / 311

14. Image
How to change the clamp delay - clamp width
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Image → Timings → Advanced
settings .
Image 14-34
Timings, advanced settings
2. Press ENTER to select.
Image 14-35
Clamp delay
3. Use the ▲ or ▼ key to select Clamp Delay or Clamp Width and use the ◄ or ► key to change the value.
Or,
press
ENTER to open the speci fi c adjustment menu.
14.6 Image File Services
14.6.1 Files and fi le manipulations
Connecting a new source.
Source dependent adjustments like image settings, aspect ratio and timings are stored in a dedicated image fi le.
Before using a new source, a correct image fi le has to be installed. The projector’s memory contains a list of fi les corresponding to
the most used sources. When the new source corresponds with one of these fi les, the fi le can be loaded and saved for future use.
When there is a little difference, the fi le can also be loaded and then edited until the source specs are reached.
VESA standards and video standards are pre-programmed.
Possible fi le Manipulations
The following fi le manipulations are possible :
• Load : load the settings of a selected fi le for the current selected source of the active window (main or PiP)
• Rename : renaming a fi le.
• Delete : deleting a fi le (only custom fi les)
• Delete all : delete all custom fi les
• Options : way of loading a fi le when a source is selected.
14.6.2 Manual Load fi le
How to load
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Image → Image File Services
→ Manual Load .
R5906730 HDF WLP SERIES 01/08/2017 147