Barco HDF W series, Use And Installation Manual

Page: 61 / 319

5. Getting started
Common address
Projector will always execute the command coming from a RCU programmed with that common address.
Why a projector address ?
As more than one projector can be installed in a room, each projector should be separately addressable with an RCU or computer.
Therefore each projector has its own address.
Set up an individual Projector Address.
The set up of a projector address can be done via the software. See chapter ’Projector Control’, ’Projector address’.
Projector controlling.
Every projector requires an individual address between 0 and 255 which can be set in the Service mode.
When the address is set, the projector can be controlled now:
•
RCU for addresses between 0 and 9.
• computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Common Address
Every projector has a common address ’0’ or ’1’. The choice between ’0’ and ’1’ can be selected in Projector Control → Projector
address → Common address .
5.9 Source selection
Source selection when no picture in picture is active
Use the digit keys on the remote control or local keypad to activate the desired source.
Source selection when picture in picture is active
Use the Window button on the remote control or the local keypad to select the main window or the picture in picture (PiP) window.
MENU
EXIT
ENTER
PAUSE
TEXT
PHASE
TINT
COLOR
BRIGHTN
CONTR
9 0
7 8
5
6
3 4
1 2
LENS
LENS
ZOOM
LENS
SHIFT
LENS
FOCUS
SHARPN
LENS
SHIFT
5
*%
3$
7
7(
51
3
,3
:
,1
'2
:
5
,*
*
,1*
$8
7
2
,0
$*(
1 2 3 4 5
6 7 8 9 0
MENU
EXIT
ENTER
RGB
STBY
PAUSE TEXT
PATTERN WINDOW PIP LENS
AUTO
Fn
Image 5-8
Window selection button
R5905158 HDF SERIES 16/06/2015 57