Barco HDF W series, Service Manual

Page: 48 / 337

5. Troubleshooting
Code 6031: “Board id: pmp write error” (Error)
Situation Solution
Malfunction I²C communication on
the PMP board. Other input boards,
the Display board, the WARP module
and the Input & Communication unit
also have “Board id read errors”. Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
Code 6032: “Board id: communication interface unknown format” (Warning)
Situation Solution
Old projector software installed. The
ID parameters of the communication
interface are written in a format
which is not known by the projector
software. Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from
https://my.barco.com .
Communication interface has invalid
fi rmware.
Replace the communication interface. See "Removal of an input module", page 146.
Corrupt projector software. Reinstall the latest projector software.
Code 6033: “Board id: communication interface not accessible” (Error)
Situation Solution
Communication Interface board is
not installed. Install the Communication Interface board.
Only the ID parameters of the
Communication Interface are not
accessible. The ID parameters of all
other boards are accessible. Ignore this error message unless other functionality of the Communication Interface fails
as well. If so, replace the Communication Interface board.
The Board ID of all other boards
are also NOT accessible. This
may indicate a malfunction I²C
functionality on the PMP board.
1. Reboot the projector.
2. Replace the PMP board. See "Replacing the PMP board", page 156.
Malfunction Communication
Interface. Replace the Communication Interface board.
Code 6034: “Board id: communication interface read error” (Error)
Situation Solution
Malfunction Communication
Interface board. The projector
can not read from the installed
Communication Interface board. Replace the Communication Interface board.
Malfunction I²C communication on
the PMP board. The input boards,
the Display board and the WARP
module also have “Board id read
errors”. Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
Code 6035: “Board id: communication interface write error” (Error)
Situation Solution
Malfunction Communication
Interface board. The projector
can not write to the installed
Communication Interface board. Replace the Communication Interface board.
Malfunction I²C communication on
the PMP board. The input boards,
the Display board and the WARP
module also have “Board id read
errors”. Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
44 R5905312 HDF W SERIES 24/01/2013