Barco HDF W series, Service Manual

Page: 178 / 337

11. Lamp Power Supply
11.3 Installation of a LPS module
Necessary tools
• Flat screw driver.
• Torque wrench with a 10 mm hexagon socket.
How to install
1. Before inserting an LPS unit, place the mounting pin at the backside in its correct position.
A
B
Image 11-7
Mounting pin
A To be built-in in the left position
B To be built-in in the right position
For a LPS unit to be built-in at the left side of the LPS compartment, the positioning pin must be in the left position when seen
from the backside of the unit.
For a LPS unit to be built-in at the right side of the LPS compartment, the positioning pin must be in the right position when seen
from the backside of the unit.
To move the pin to the left or the right, pull on the pin and slide it to the left or to the right.
2. Take the new LPS module and slide in the LPS module in the LPS compartment so that the LAMP OUT connection points are to
the upper side.
Image 11-8
LPS module insertion
3. Slide the fi xation frame on the front of the LPS units in such a way that the fi xation pins match the fi xation holes.
174 R5905312 HDF W SERIES 24/01/2013