Barco Graphics 908, Owner'S Manual

Page: 82 / 111

7. Service Mode
7.3.9 Common Address
What can be done?
Every projector listens to a common address. This common address can be set to ’0’ or ’1’. When a RCU is programmed with that
common address, every projector with that same common address will follow up the commands given by that RCU.
Why 2 different Common Addresses?
The reason to have the choice to select between common addresses is, to avoid controlling of other IR controlled units, e.g. a TV
set with standard common address 0.
How to change the Common Address?
1. Push the ↑ or ↓ keys to highlight Common Address .
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
ABL CONTROLLER
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 7-22
2. Press ENTER to toggle the Common Address between ’0’ and ’1’.
3. Press EXIT to return to the Service Mode menu.
7.3.10 ABL Controller
What can be done?
To guarantee perfect dark images in e.g. night scene simulations the ABL control can be switched from a ’continues’ control, in sync
with the vertical refresh rate of the projected image, to a ’forced’ control according to a programmable ABL timer setting.
When starting up the projector, the first 20 minutes the ABL control will always run in a ’continues startup’
mode.
How the change the ABL Control mode?
1. Push the ↑ or ↓ keys to highlight ABL Controller .
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
ABL CONTROLLER
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 7-23
2. Press ENTER to select.
The ABL Controller menu will be displayed.
78 R5976633 BARCO GRAPHICS 908 / BARCO REALITY 908 05/06/2003