![background image](http://html1.mh-extra.com/html/barco/galaxy-nh-12/galaxy-nh-12_user-manual_3835328048.webp)
5. Setup
Image 5-15
Image 5-16
The use of a sheet of paper held in front of the screen can be useful to determine the focus plane (position
for best focus)
5.7
Setup the baud rate for serial communication
What can be done ?
The RS232 IN port of the projector allows you to communicate with any other equipment disposing of an RS232 port (generally a
PC) using the RS232 protocol. The baud rate must be set to the same value on both the projector and the other equipment.
How to change the baud rate?
1. Press
MENU
to activate the Tool bar
2. Press
→
to select the
Installation
item
3. Press
↓
to Pull down the
Installation
menu
4. Use
↑
or
↓
to select
RS232 baud rate
Image 5-17
5. Press
→
to pull down the menu
6. Use
↓
or
↑
to select the desired baud rate
7. Press
ENTER
Always select the highest rate unless otherwise speci
fi
ed.
44
R59770121 NH-12 04/05/2011
Summary of Contents for Galaxy NH-12
