Barco Galaxy NH-12, User Manual

Page: 149 / 193

7. Advanced
Internal black level versus Beta Planes
In the same way as for the soft edge adjustment (Internal vs Alpha planes) this black level adjustment can be fi xed internally by
using a dialog box or externally by uploading a user de fi ned Beta plane . This beta plane will contain the values for the brightness
offset to be applied to the image.
Both methods will allow to compensate for the typical double brightness phenomenon in the soft edge zones by increasing the
brightness of the rest of the image.
channel 1 channel 1
Overlap zone (double brightness)
channel 1&2
pulled up
Image 7-167
Black level : double brightness compensation
It is worth noting however, that (internal) black level (via the dialog box) is to be used for simple linear soft
edge zones (like in the illustration above). Curved soft edge zone should be done using (external) beta planes.
The Black level adjustment has to be done for all the channels (projectors)
7.9.7.5.2 Internal black level
What can be done ?
Internal black level can be adjusted via the projector’s software using a dialog box. The dialog box allows to add an offset to the
black level of the image in the zones outside the soft edge zones. The range goes from 0 to 255.
How to adjust the internal black level ?
1. Press the MENU key to activate the Tool bar.
2. Push the cursor key ← or → to highlight Display setup
R59770121 NH-12 04/05/2011 145