![background image](http://html1.mh-extra.com/html/barco/galaxy-nh-12/galaxy-nh-12_service-manual_3838748070.webp)
7. Electronic parts and servicing procedures
7.6.2
Diagnostics of the SPG
Diagnostics
If the lamp fails to ignite after you switched the projector from standby to operation, you can try to indicate the error by using the
table below.
Situation
Solution
You can hear the SPG module three times clicking in an attempt to ignite
the lamp. The voltage on the “LAMP OUT” pins of the LPS module is
fi
rst 140 volt during the attempt to ignite and then drops to 0 volt.
Note
: The ambient noise must be low to hear the SPG clicking in an
attempt to ignite the lamp.
•
The LPS and SPG seem the work normally but
the lamp is bad. Install another lamp house.
•
If the problem remains, replace the SPG
module.
You can not hear the SPG module three times clicking in an attempt to
ignite the lamp. The voltage on the “LAMP OUT” pins of the LPS module
is
fi
rst 140 volt during the attempt to ignite and then drops to 0 volt.
Note
: The ambient noise must be low to hear the SPG clicking in an
attempt to ignite the lamp.
•
Check the cabling of the SPG module.
•
Replace the SPG module.
You can not hear the SPG module three times clicking in an attempt to
ignite the lamp. The voltage on the “LAMP OUT” pins of the LPS module
is below 140 volt during the attempt to ignite.
Note
: The ambient noise must be low to hear the SPG clicking in an
attempt to ignite the lamp.
•
Check the cabling of the LPS module.
•
Replace the LPS module.
7.6.3
Removing the SPG
Necessary tools
•
Torx screwdriver T10
•
Nut spanner 10 mm
•
Allen key 4 mm
How to remove the SPG?
1. Remove the rear cover (see concerning chapter)
2. Remove the fan outlet (see concerning procedure)
3. Remove the lamp (see concerning chapter)
4. Remove the four screws
fi
xing the lamp power cover
Image 7-60
Lamp power cover:
fi
xing screws
5. Remove the lamp power cover
6. Disconnect the lamp power cables on the LPS by removing the nuts
66
R59770141 GALAXY NH-12 20/02/2008
Summary of Contents for Galaxy NH-12
