Barco Galaxy 12 High Brightness+ R9040370, Owner'S Manual

Page: 32 / 173

4. Connections
Lamp run time indication
The total lamp runtime for a safe operation is maximum 500 (Typical) or 1000 (Maximum) hours, do not use the lamp any longer.
Operating the lamp longer than 500 (Typical) or 1000 (Maximum) hours may damage the projector.
When the maximum lamp runtime hours is reached, the following warning will be displayed, from then on, each time the projector is
started up, this warning will be displayed.
Remaining
Lamp run time
20h
Image 4-2
Press ENTER to remove this warning.
Always replace with the same type of lamp, call a BARCO authorized service technician for this lamp replacement.
C
AUTION
:
Using a lamp for more than 500 (Typical) or 1000 (Maximum) hours is dangerous as the lamp could
explode.
Lamp Light Output Indication
When starting up the projector, the center lumens measurement is performed, when the lamp light output is lower than 50 % of the
initial value, the lamp light output warning will be displayed.
WARNING
Lamp run time is X hours
The light output of the lamp
is less
than 50% of its initial value.
It is advisable to replace the
lamp
before damage occurs.
<ENTER> to confirm
Menu 4-1
Press ENTER to remove this warning.
4.3 Switching to standby
How to switch to standby?
1. Press
Standby
to switch the projector to standby.
4.4 Switching off
How to switch off the projector?
1. Press first
Standby
.
2. Let cool down the projector until the fans stop blowing, at least 15 min.
3. Switch off the projector with the power switch.
28 R5976780 GALAXY SXGA+ SERIES 14/10/2005