Barco G62, User Manual, Page: 60 / 124

R5914653 /02 G62 60
9.1 Projector ID
About projector ID
Assign an remote code for the projector from 00 to 99. Use this code as the projector ID when controlling the
projector by RS232, HDBaseT, Telnet or other control methods.
9.2 Remote Setup
About remote setup
Configure the settings of the Infra-Red (IR) remote control.
Remote code
Assign an remote code from 00 to 99 for the remote receivers on the projector. The projector only responds to
the IR remote control set with the same remote code.
Remote receiver
Set the remote receiver for the projector to control the communication between the projector and the IR
remote.
• Front: Enable or disable the front remote receiver.
• Top: Enable or disable the top remote receiver.
• HDBaseT: Select On to set the HDBaseT terminal as the remote receiver.
User Button 1 / User Button 2
Assign a function to the User 1 / User 2 button on the remote control. It allows you to use the function easily
without going through the OSD menus. The available functions for the User 1 / User 2 button are:
• Freeze Screen
• Blank Screen
• Save to User
• PIP/PBP
• Aspect Ratio
• Show Message
• User Data
• Network Setup
• Projector ID
• Orientation
• Custom RGBCMY
• Multi-Projection
• Reset Selective
9.3 Network Setup
About network setup
Configure the projector’s network settings.
Ethernet
Configure the projector’s Ethernet settings when connecting to a wired network using an RJ-45 cable.
• RJ-45: Specify the LAN interface to RJ-45.
• HDBaseT: Specify the LAN interface to HDBaseT.
• MAC Address: Display the MAC address. (Read only)
• Network Status: Display the network connection status. (Read only)
User controls — Communication menu