Barco G60 W Series, User Manual

Page: 24 / 34

R5910890 /01 G60 W series 24
3.5 Warp settings, Moving Cursors
Overview
Move the cursors on the projection screen to perform warping.
• Select cursor. To select a cursor, click the cursor or use “ W ” , “ A ” , “ S ” , and “ D ” on the keyboard.
The selected cursor will change to blue.
• Move cursor. Use arrow keys on the keyboard to move the selected cursor.
•
Adjust cursor
- Start with a minimal number of grids and gradually increase the number of grids. It is advisable to
starting with 2 x 2 setup.
- Using fewer grid number allows for easier warping control.
- As shown below, adjust the outer cursors in red first, and then adjust the inner cursors in green.
Image 3-6
If starting with larger grid number, all the warping settings will be lost when decreasing the grid
number.
3.6 Warp settings,Test Pattern
Overview
Test pattern helps to tune the edge blending. When performing edge blending, test pattern helps to align the
two projection screen as shown in the example below.
• Enabling the test pattern to assist in tuning the edge blending.
Using the Warping and Blending tool