208
FSN Series • User’s Guide
5. Menu Orientation
System Menu
bñíÉêå~ä=aph=pÉíìé=jÉåì
From the
System Menu
, press
{External DSK Setup}
to display the
External DSK Setup
Menu
, which enables you to set up the
DSK Cut
and
Fill
inputs on the
M/E Card
. These
two inputs are only used on the
DSK
when
{External Key}
is enabled.
The figure below illustrates a sample menu, with the
DSK Fill
connector selected.
Figure 5-97.
External DSK Setup Menu, DSK Fill selected (sample)
The
External DSK Setup Menu
is divided in half:
•
The left side of the
Palette
shows the
Rear I/O View
, in which only the two
DSK
input connectors are active. All other output connectors are grayed out.
•
The right side of the
Palette
shows the
External DSK Table
, which provides
information about each input.
To set up an external DSK input, press the desired connector in the
Rear I/O View
. In the
External DSK Table
, the selected input is automatically highlighted.
The following topics are discussed in this section:
•
•
Note
The
DSK Cut
input can not be adjusted. To prevent error
messages, if the input is not used, turn off error reporting.
