202
FSN Series • User’s Guide
5. Menu Orientation
System Menu
~
Select
Off
to process the input with multiple samples for every pixel.
This mode generally results in a “softer” image.
•
Press
{Sample Phase}
to display the
Sample Phase
value button. Use the
button (or knob) to adjust the input’s A/D converter, allowing you to select where
pixels are sampled (ideally, on the pixel’s peak).
Range
: -16 to 15
Default
: 0
For optimum visual results when adjusting high-resolution sources, output a burst
test pattern from the source, and adjust for minimum noise.
•
Press
{Adjust H Timing}
to adjust the image’s horizontal timing. Three value
buttons appear:
~
Use the
{H Pos}
button (or knob) to set the start of the active area’s
horizontal offset from H sync.
~
Use the
{H Active}
button (or knob) to set the width of the active area.
~
Use the
{H Total}
button (or knob) to set the total pixel count per line.
•
Press
{Adjust V Timing}
to adjust the image’s vertical timing. Two value buttons
appear:
~
Use the
{V Pos}
button (or knob) to set the start of the active area’s
vertical offset from V sync.
~
Use the
{V Active}
button (or knob) to set the number of vertical lines in
the image.
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC
.
Sample
Phase
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC
.
Adjust
H
Timing
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC
.
Adjust
V
Timing
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC
.
Note
V Total
is a fixed value which cannot be adjusted.
