100
FSN Series • User’s Guide
4. Installation
FSN-1400 System Connections
cpkJNQMM=póëíÉã=`çååÉÅíáçåë
The figure below illustrates the connections on the
System
card’s I/O panel, plus the power
connections. Use this figure for reference during installation.
Figure 4-9.
System card and power connections
Use the following steps to install “system” connections on the
FSN-1400
:
1.
Ensure that the
FSN-1400
is properly rack mounted. If not, refer to the “
” section on page 98 for instructions.
2.
On the
System
card’s I/O panel, ensure that the
Ethernet Port
is connected to
the
Ethernet Switch
, and the
Switch
is connected to
Ethernet Port 1
on the
control panel.
12
13
14
GPIO
Tally
Ref In
Loop
Ref Out
Ethernet
Serial 2
Serial 1
100 - 240 VAC
8A, 50 - 60 Hz x2
2
1
To
Tally “Y” Adapter
AC
AC
Reference
Video In
Reference
Video Loop Out
To
Control Panel’s
Ethernet Port 1
Note
As an alternate method, you can use a direct Ethernet
connection between the
FSN-1400
and the
Control Panel
.
