Barco Freya, User Manual

Page: 259 / 370

259 R5910032 /00 Freya
1
2
Image 14 – 3
2. Select the Host name (reference 1) and enter the desired name.
To indicate that projector parameters are being edited an asterisk is displayed and the Save icon
(reference 2) is now enabled.
3. Click Save .
New host name is active now. The asterisk is removed and the Save button is greyed out.
Host name may contain only the ASCII letters 'a' through 'z' (in a case-insensitive manner), the
digits '0' through '9', and the minus sign ('-').
14.1.4 Assigning a network address
Location & access
Menu: Configuration > System access> Network configuration
Level: Administrator, Service technician
The projector has been configured as receiving an IP address automatically. This means that by
default you should not have to configure anything. However, if the projector can not find an
appropriate DHCP server on the network, or if the projector is not connected to any network in
general, the projector will trigger an error instead.
If you are unsure on what IP address, subnet mask or default gateway address the projector should
receive, please contact your local network administrator.
How to set up automatically
1. While in Configuration > System access > Network configuration , click on the edit icon of the projector
interface.
The projector network interface is displayed.
Configuration - System access