Barco Freya, User Manual

Page: 222 / 370

R5910032 /00 Freya 222
A Save as dialog is prompted.
10. Enter a name for the cue and confirm with Save .
Click Save .
11.3.3 Devices and commands
Overview
Device type Commands List
GPIO
• Set output: to set one or more outputs to the desired value (0 or 1).
• Pulse up: to realize a rapid change of amplitude of the output (0 to 1).
• Pulse Down: to realize a rapid change of amplitude of the output (1 to 0).
• Set Up: to set output to 1.
• Set Down: to set output to 0.
PLAYER
• Play: to start or resume the playback
• Stop: to stop the playback
• Pause: to pause the playback. The last played image remains on the screen. If the
‘ Duration in minutes ’ parameter is different than 0, the playback will automatically
resume after the given amount of time.
• Pause (seconds): pause is defined in seconds
• Resume: to resume a paused playback.
• Enable Schedule: to enable the scheduled mode.
• Disable Schedule: to disable the scheduled mode.
• Emergency Stop: to disable the scheduled mode, stop the playback and trigger the “ On
Emergency Stop ” event.
• Insert Show: to dynamically insert a show inside another main show in which the cue
was inserted. The insertion is done at selection time. Note that other actions in the cue
will be ignored.
• Rewind (seconds): to rewind the defined time.
• Play Scheduled Show: to start the playback of a scheduled show between scheduled
time and maximum delay.
Projector
• Close Dowser: to close the dowser of the projector.
• Open Dowser: to open the dowser of the projector.
• Turn Lamp On: to turn the projector lamp on.
• Turn Lamp Off: to turn the projector lamp off.
• Execute Macro: to request macro execution by the projector. Macro selection from
macro list is necessary.
TCP/UDP
(device)
• Send Text: to send a text command to the device. Special characters or delimiters have
to be replaced by the
“ \ ” character followed by the corresponding hexadecimal value on
two digits. For instance, the command can send the text “ mute=0\0D\0A ” , where “ \0D ”
replaces the carriage return ( “ \r ” ) and “ \0A ” replaces the new line ( “ \n ” ).
• Send Hex: to send a hex value to the device.
• Send Binary: to send a binary value to the device.
JNIOR
• Set outputs: to set one or more outputs to the desired value (0 or 1).
• Pulse up: to realize a rapid change of amplitude of the output (0 to 1).
• Pulse Down: to realize a rapid change of amplitude of the output (1 to 0).
• Set Up: to set output to 1.
• Set Down: to set output to 0.
• Clear input counters: to clear counters for the given JNIOR input.
• Clear input usage meter: to clear the usage meter for the given JNIOR input.
• Clear output usage meter: to clear the usage meter for the given JNIOR output.
• Reset input latch: to reset the given JNIOR input latch.
• Execute Macro: to request a macro execution by the JNIOR. The macro name should
match the name of an existing macro on the JNIOR.
Configuration - Media server automation