Barco FLX-60, Installation Manual

Page: 54 / 82

4. Installation procedures
4.5 Standard clip mounted FLX-60 pixel
The cutting dimensions for a standard clip mount makes it possible to install or remove the FLX-60 pixel via
front or back access.
The mounting hole for the FLX-60 pixel must require the speci fi cation of the cutting dimensions for standard
clip mount. See chapter "Mechanical requirements", page 10.
How to install the FLX-60 pixel in a standard clip mounting hole?
1. Is there back access?
If yes, you can choose to connect the FLX-60 pixel with the connector string now or wait until the FLX-60 pixel is mounted.
If no, pull the pixel socket of the connector string through the mounting hole and connect the FLX-60 pixel with the connector
string.
2. Compress the three clips of the FLX-60 pixel and approach the mounting hole either from the front or form the back as illustrated.
Make sure that the clips are aligned with the largest cutouts in the mounting hole.
Note: The pixel orientation determines also the cable orientation. In and Out of the pixel socket should be in line to avoid
useless cable bends.
Image 4-9
3. Compress the three clips of the FLX-60 pixel and rotate the FLX-60 pixel for 40° as illustrated. As a result the FLX-60 pixel will
be fi rmly locked in the mounting hole. Note that the rotation can be clockwise or counterclockwise.
40°
Image 4-10
50 R59770419 FLX-60 12/05/2010