1. FLM/SLM adaptor plate
W
ARNING
:
Never open an interlocking adapter of a stacked projector which is still suspended. First place
the stacked projectors on the floor.
1.4
Aligning stacked FLM/SLM projectors
Necessary tools
8 mm Allen key.
How to align two stacked FLM/SLM projectors ?
1. Make sure that the internal hatch pattern projected by the reference FLM projector is sharp and has a perfect rectangle outline.
If this is not the case, readjust the reference FLM projector before aligning the stacked SLM projector with the reference hatch
pattern.
Note:
The reference projector in a stacked configuration is the lowest projector in case of table mount and the uppermost
projector in case of ceiling mount.
2. Project with the stacked SLM projector the same internal hatch pattern as the reference FLM projector.
Tip:
Use a white colored hatch pattern for the reference projector and e.g. green colored for the stacked projector. This
makes it easier to see the different between both hatch patterns projected.
3. If necessary, adjust the rotation of the stacked SLM projector with respect to the reference FLM projector by turning in or out the
height adjustment ring of the interlocking adaptors at the rear of the stacked SLM projector. Adjust until the outline of the hatch
pattern is most symmetric with the reference hatch pattern.
Tip:
You can increase leverage by using a screw driver in the holes of the adjustment ring
Rotation
Image 1-10
4. If necessary, adjust the inclination of the stacked SLM projector with respect to the reference FLM projector by turning the height
adjustment ring of the interlocking adaptor at the front of the stacked SLM projector in or out. Adjust until the outline of the hatch
pattern is most symmetric with the reference hatch pattern.
Inclination
Image 1-11
5. If necessary, adjust the skew of the stacked SLM projector with respect to the reference FLM projector by turning the screw Q in
or out using a 8 mm Allen key. The screw Q is located behind the cover of the lamp of the reference FLM projector, just above
the volt meter. Adjust until the outline of the hatch pattern is most symmetric with the reference hatch pattern.
Note:
See owners manual of the FLM projector, to access the skew adjustment screw Q.
R5976959 FLM/SLM ADAPTOR PLATE 24/05/2006
7
