Barco FLM HD18, User Manual

Page: 79 / 193

9. Image menu
Image 9-50
Image 9-51
7. Adjust the red black level on a minimal value
8. Select Black balance blue and adjust the blue black level on a minimal value.
Note: This minimal value is not necessary , provided that the 2 other colors are not influencing too much the color to be adjusted,
in fact the aim is to minimize the effect of the two other colors since there is a risk of reaching too soon the 50% transition
due to the contribution of these two other colors signals.
9. Select Black balance green and adjust the Green black level until bright spots appear on the screen.
10.Select Black balance blue adjust the Blue black level until bright spots appear on the screen.
11.Select Black balance red adjust the Red black level until bright spots appear on the screen.
The projected image should now be noisy full black
If one uses a gray scale pattern, the bright spots should appear in the black bar.
Performing White input balance
1. Connect the source you want to project.
2. Select a white pattern (or gray scale as alternative).
3. Press MENU to activate the menus.
4. Use the ▲ or ▼ key to select
Image
and press ENTER .
5. Use the ▲ or ▼ key to select
Image settings
and press ENTER .
6. Use the ▲ or ▼ key to select
Input balance
and press ENTER .
7. Use the ▲ or ▼ key to select
White balance
and press ENTER .
8. To start, use the ▲ or ▼ key to select
White balance red
and press ENTER .
Image 9-52
Image 9-53
Image 9-54
Image 9-55
Image 9-56
9. Adjust the red white level (gain) on a minimal value
R5976986 FLM HD18 01/09/2006 75