Barco FLM HD18, User Manual

Page: 72 / 193

9. Image menu
The higher the value, the higher the tint.
Image 9-15
Image 9-16
Image 9-17
Image 9-18
9.3.5 Phase
About Phase adjustment
When displaying computer patterns or graphics (RGB or YUV signals) which are very detailed (tilting, vertical stripes, etc. ), jitter
in picture (mis-sampling) may occur, causing horizontal stripes in portions of the screen. When this jitter occurs, adjust ’Phase’ for
optimum image.
Image 9-19
Jittering on image
How to change the phase?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select
Image
and press ENTER .
3. Use the ▲ or ▼ key to select
Image settings
and press ENTER .
4. Use the ▲ or ▼ key to select
Phase
and press ENTER .
The Phase progress bar appears.
5. Use ◄ or ► to change the phase and refine the jitter.
Note: Don’t mix up with wrong number of total pixels. If the jitter doesn’t disappear with the phase adjustment, check the total
number of pixels. (Best image = pixel on pixel off pattern. For example: shut down screen of a PC)
68 R5976986 FLM HD18 01/09/2006