![background image](http://html1.mh-extra.com/html/barco/fl-fs40-mkii/fl-fs40-mkii_installation-manual_4126766088.webp)
R5913250 /02
FL-FS40 MKII
88
5.7.7 Wired RC connection
About
The remote control can also be directly wired to the projector from the stereo jack connector on the remote,
(See
“
”
, page 84
), to the RC connector on the back panel of the projector.(See section
“
Connector Panel
”
)
In this mode, the projector will not be affected by signals from other non-wired remote controls.
When using wired remote control, the broadcast address must be set to
“
Generic ID (0)
”
. See the menu in
Enable / Disable Remote Control
”
, page 87
.
It is not possible to program the remote control in wired mode. (Directly connected, no sense in programming).
Summary of Contents for FL-FS40 MKII
