Barco F90 - W13WUXGA, User Manual

Page: 39 / 103

4. Physical Installation
4. Go to Main Menu / Installation / Orientation and select the correct orientation for your setup.
5. Go to Main Menu / Test Pattern s and select an internal hatch pattern to display on the screen.
6. Adjust the position (height and angle) of the rigging frame until the projected hatch pattern is a level and perfect rectangle.
If applied in a motion rig, care must be taken to stay within the environmental speci fi cations for vibration and
shock. It may also be necessary to use additional, custom means to stabilize the projection lens to make sure
that the projected image remains in position and properly focused.
4.6 Projector safe attachment points
About
Due to use of a Rigging Frame or other equipment, the projector has some de fi nes anchor points that shall be used. See the
illustration below.
Note that there is only this 4 selected attachment points that is approved as anchor points for the unit.
Anchorpoints.
For attaching to rigging frame or similar.
1
Image 4-3
Item Thread Dimension Max Hole Depth Application
1 M6 15mm Anchorpoint / Ceiling / Rig
Mount
601–426 F70 SERIES 24/10/2017 35