![background image](http://html1.mh-extra.com/html/barco/f80-q12/f80-q12_user-manual_4243459122.webp)
R5906852 /09
F80
122
10.1 Remote control
10.1.1 Broadcast address
About broadcast address
Broadcast address is a common address that can be set on the projector. That can be “0” or “1”. The default
broadcast address is '0'.
Any command coming from an RCU programmed with that common address will be executed.
How to the broadcast address
1.
In the main menu, select
Settings
→
Communication
→
Remote control
.
Image 10–1 Communication menu, Remote Control
The Remote control menu is displayed.
Image 10–2 Example of the Remote control menu
2.
To change the broadcast address select the radio button of your choice.
The following choices are possible:
•
Generic IR (address 0)
•
Barco broadcast IR (address 1)
3.
Select
APPLY
and click
OK
to apply the changes.
10.1.2 Projector address
About individual projector address
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or with a computer using serial communication. Therefore each projector has its own address. The
factory default individual projector address is ‘0’.
When the address is set, the projector can be controlled with the RCU. Only addresses between 0 and 31 are
supported for the RCU.
Next to an individual projector address, each projector has also a broadcast address for group control.
Summary of Contents for F80-Q12
