Barco F70 Series, User Manual

Page: 149 / 218

149 601–426 /15 F70 Series
Image 10–1 Communication menu, Remote Control
The Remote control menu is displayed.
Image 10–2 Example of the Remote control menu
2. To change the broadcast address select the radio button of your choice.
The following choices are possible:
• Generic IR (address 0)
• Barco broadcast IR (address 1)
3. Select APPLY and click OK to apply the changes.
10.2.2 Projector address
About individual projector address
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or with a computer using serial communication. Therefore each projector has its own address. The
factory default individual projector address is ‘0’.
When the address is set, the projector can be controlled with the RCU. Only addresses between 0 and 31 are
supported for the RCU.
Next to an individual projector address, each projector has also a broadcast address for group control.
How to change
1. In the main menu, select Settings → Communication → IR control .
Image 10–3 Communication menu, Remote Control
The Remote control menu is displayed.
System settings menu