Barco Event Master E2, User Manual

Page: 177 / 307

7. System Setup
7.16 Con fi guration Menu > Add MVR Outputs
General
In this procedure, you will add MVR Outputs to the system.
Prerequisite
• Ensure that you are familiar with the Con fi guration Menu . For details on this menu, please refer to chapter "Con fi guration
Menu", page 76
If more than one Output is utilized, repeat the below steps until all outputs are added and adjusted .
Add MVR Output
1. Click on the MRV tab to select the outputs that will be de fi ned.
2. Click on the +Add MVR Output blue button to enter the Add mode.
3. Click on the connector that the input signal is connected to de fi ne it as an output.
4. Click on the Done Adding button to exit the Add mode.
(Optional) Edit the Name
1. Double click on default name in the Name list to edit the name.
2. When the area turns blue, click the eraser icon to clear the fi eld.
3. Type a new name and hit enter when done.
(Optional) Adjust Output Parameters
Click on the “Adjust” tab that is located on the top. From this menu you can adjust:
1. Edit the name.
2. Select Format value, color space and connector type.
3. Enable Test Patterns with raster box and enable diagonal motion.
4. De fi ne the Area of interest (AOI).
5. Perform color adjustments.
6. Read the timing parameters associated with the selected format.
7. Adjust HDMI parameters.
(Optional) Auto create MVR Outputs
If the Auto create MVR Outputs is pressed, then the software will add all unassigned outputs to the output list and number them
sequentially.
(Optional) Delete Outputs
1. Click on the blue button Delete MRV Output(s) .
2. From the Name list click on the “ x ” space next to the Output(s) you wish to delete.
3. Hit the red button Delete Output(s) button. All of the selected Outputs will be removed from the list.
R5905948 E2 12/12/2014 173