Barco Eos, User Manual

Page: 109 / 170

6. Advanced configuration
Barco – Eos Workstation for Windows – DOC-3062-2 – Revision 12 – August-2004
____________________________________________________________________________
6-8
6.1.4 Switching resolution of graphic cards
01
23
8
4567
9 AB
D EF C
Figure 6-8
Rotary switch for selecting appropriate resolution
The appropriate resolution is selected with a rotary switch on the board. The figure above shows this rotary
switch located on top of an inserted graphics card. All cards must be set to the same resolution! The following
table shows the possible settings:
switch projection module resolution DDC active
0 O
VER
V
IEW
-
M
L VGA 640×480 no
1 O
VER
V
IEW
-
M
L
O
VER
V
IEW
-
M
D
O
VER
V
IEW
-
M
E
SVGA 800×600
SVGA 800×600
SVGA 800×600
no
2 O
VER
V
IEW
-
M
L XGA 1024×768 no
4 O
VER
V
IEW
-
M
P
A
TLAS
C4 67" poly-silicon engine
XGA 1024×768
XGA 1024×768
no
5 O
VER
V
IEW
-
M
P
A
TLAS
C4 67" poly-silicon engine
O
VER
V
IEW
-
M
E
SVGA 800×600
SVGA 800×600
SVGA 800×600
no
6 digital output, 60 Hz VESA timing SXGA 1280×1024 no
7 O
VER
V
IEW
-
M
P
A
TLAS
67C4-PSI
modules from Q2/03 and newer
XGA 1024×768 no
8 O
VER
V
IEW M
DR50/67-DL
(1)
SXGA 1280×1024 no
9 A
TLAS
CS4, S70
digital output via DVI connector
SXGA 1280×1024 no
F digital output with DDC
connected display device provides DDC information e.g.
VGA
640×480
SVGA 800×600
XGA 1024×768
WXGA 1280×768
SXGA 1280×1024
yes
analog output (CRT) without DDC software defined no
analog output (CRT) with DDC
connected monitor provides DDC information. DDC defined yes
Table 6-4
selectable resolutions of the UGX and AGX G
RAPHIC
C
ARD
(1) For O
VER
V
IEW M
DR50/67-DL usually the switcher position F is selected as it provides DDC information. Nev-
ertheless in a set-up where DDC can not be evaluated, switcher position 8 can be selected instead.
For AGX Graphic Cards switcher position 7 and 8 is only available with BIOS revision FMW-
3000-06 or newer and switcher position 9 is only availabe with BIOS revision FMW-3000-08
or newer.
The Version of the BIOS revision is printed on the mikrocontroller on the graphic card.
If a digital V
ISU
P
LUS is connected between E
OS
and projection module nevertheless the resolution of the projection
module has to be chosen.