3. Getting started
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 11 – November-2004
___________________________________________________________________
3-52
3.4.4
Configuring an X server for Visu
Plus
standalone
The configuration script for an X server for V
ISU
P
LUS
standalone is started as explained in section
. As well the resolution of the projection modules controlled via V
ISU
P
LUS
as the arrangement of the
modules has to be inserted.
Resolution of output
The resolution of the projection modules controlled via V
ISU
P
LUS
has to be indicated:
You want to install the X Server for The Visu Plus
following values are needed:
- Visu Screen Resolution
- Visu Screen Arrangement
Enter the Visu Screen Resolution (Width x Height) [1024x768]: 800x600
Screen arrangement
The arrangement of the projection modules is indicated in the following form:
<w>x<h>
Here
<w>
and
<h>
give the number of columns and rows. For exapmle:
4x2
4 monitors next to each other, 2 monitors on top of each other.
Configuring the Monolithic X Server Multiscreen Arrangement
-----------------------------------------------------------
Enter the Visu Screen Arrangement (Width x Height) [1x1]: 2x2
These are your Visu Plus settings
=================================
- Visu Screen Resolution :
800x600
- Visu Screen Arrangement :
2x2
Everything correct? (yes/no)? [yes]: y
****************************************************************
Visu Plus Standalone X Server setup done... Have fun!
NOTE: enter "service mmtserv"
to start the EOS X Server
****************************************************************
When configuration is completed, you can enter
service mmtserv
to start the X server:
eos:/opt/MMT2686/config # service mmtserv
