Barco DP2K-E series, User And Installation Manual, Page: 121 / 163

15. Maintenance procedures
15.6 Authorization to clear security warning on the projector
When is an authorization required to clear the security warning?
If a module has been removed or if the sealed compartment has been opened, an authorization will be required to clear the security
warning.
Necessary tools
Authorization pin code.
Authorization procedure to clear security warning
1. Ensure that all modules are properly installed.
2. Start up the projector (Standby mode).
3. Initiate authorization by pushing the Key button on the Local Keypad:
The color of the backlight of the Numeric keys 1 to 6 of the Local Keypad changes from white to yellow.
4. Enter pin code within 5 seconds.
- In case no keys are pressed, the color of the backlight of the Numeric keys 1 to 6 changes back to white.
- In case of an incorrect code entry, the color of the backlight of the Numeric keys changes to red for 1 second and then back
to white .
- In case of a correct code entry, the color of the backlight of the Numeric keys 1 to 6 changes to green for 1 second and then
back to white .
Each attempt to clear the security warning and its result (successfully or unsuccessfully) is logged inside the
projector.
R5906693 DP2K-E SERIES 19/06/2015 117