Barco DP-1200, Installation Manual

Page: 18 / 134

2. General
2.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found,
fi le claim with carrier immediately. The Barco Sales and Service of fi ce should be noti fi ed as soon as possible.
The packaging of the DP-1200 digital projector is provided with a shock-watch label. If this shock-watch la-
bel was triggered (red colored at arrival) during transport, indicates that the package was possibly roughly
handled by the transport company. In this case, the instructions mentioned on the label, should be followed,
which are: adding a note on the “bill of lading” and informing the transport company and the Barco sales and
service of
fi ce as soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items where included:
• One GPIO data cable D-SUB 37 pins (2 meter).
• One short power link cable (mono phase) (for in case no UPS is used).
• One lamp cathode adapter.
• This manual.
One xenon bulb lamp of 2000 watt is mounted inside the lamp house at delivery. The projector lenses are not
included in the package of the projector.
Mechanical check
This check should con fi rm that there are no broken knobs or connectors, that the cabinet and panel surfaces are free of dents and
scratches, and that the operating panel is not scratched of cracked. The Barco Sales and Service of fi ce should be noti fi ed as soon
as possible.
14 R59770242 DP-1200 06/01/2009